
Above: Some common LAN designs. Cick sketch to enlarge.
So, I found myself doodling around a bit with the pencil and grid pad...
If you're reading this blog, then of course, you computer is connected to the Internet.
And, if you're not using an internal modem or an external modem with a serial cable, then you're using a Local Area Network (LAN.)
A popular format for these networks is the Ethernet (IEEE 802.11) using CAT-5 cable. That is what I'm showing at the top of the sketch in Figure (a). You've got a PC, a modem (cable or DSL for phone) and a small Ethernet hub to connect them together. Sometimes, the hub (or a small IP switch) is built into the DSL or cable modem. From their you go across the cable or phone company until you get onto the Internet.
A more complicated (and cooler because it uses RF) solution let's you access the Internet without running a network cable from the PC to the modem. In these "wi-fi" or wireless networks, a popular format is IEEE 802.11g. Many folks have those small blue Linksys WRT54G boxes and wireless cards installed in their computers. Did you know that these units share spectrum with the 2.4 GHz ham band ? The "wireless access point" (aka wireless router) typically contains antennas (1 or 2) an IP router (more about that later) TX and RX equipment and a few Ethernet ports. Being microwaves, you're mileage may vary, but you can get around 100' of range or so. Compare that with 300 ft. for the CAT-5 cables. Not bad.
Figure 'C' shows a DeLuxe setup. Long story short, you can use hubs and switches to segment your network by location or by task. Note I put in a dedicated AP for the Ham Internet (Hinternet) http://en.wikipedia.org/wiki/High_speed_multimedia
I've been reading up on what can be done with the Hinternet. I mentioned one club's experiments in a previous post. I'll report back with more later.
In the meanwhile, how advanced of a wifi setup do you have now ?
My setup strongly resembles Figure B.
I know a couple Hams that work from home that have setups more like C.
If you're back at Figure A and have questions, please let me know.
73
Scott
KD5NJR